Skip to content
Andrei VeremeenkoSCADA Systems Engineer · EPIC, Mohawk College
Visitor · read-only
1 ACTIVE

Open to full-time roles from May 2027.

Contact
Project P-03 · Sheet 1 / 1

Real-time simulation pipeline

OPAL-RT + HYPERSIM, into Ignition over DNP3

COMPLETED
  • HMI
  • PRO
  1. 01 · Problem

    An idea from my supervisor

    My supervisor proposed a simple single-line diagram model running in HYPERSIM, with one feeder, one circuit breaker and one load, and its data flowing both ways between the simulation and Ignition.

  2. 02 · Approach

    OPAL-RT and HYPERSIM, into Ignition

    • I developed a pipeline to perform power system simulations using OPAL-RT equipment and HYPERSIM software.
    • OPAL-RT runs the HYPERSIM model in real time.
    • I mapped the model's DNP3 points in HYPERSIM, so the simulated data reaches Ignition and breaker commands come back.
    • In an Ignition Perspective project I copied the single-line diagram, visualized the simulated data on it and added circuit breaker control.
  3. 03 · Stack

    What it runs on

    Model1 feeder · 1 circuit breaker · 1 load
    SimulatorOPAL-RT
    Simulation softwareHYPERSIM
    HMIIgnition
    ProtocolsDNP3
    • HMI
    • PRO
  4. 04 · Outcome

    Completed

    COMPLETEDDelivered.

    The pipeline is not in use today. Building it gave me the knowledge and skills to set up the same operation again when it is needed.

FIG 1 Data path of the simulation pipeline: HYPERSIM, OPAL-RT and Ignition Perspective.

Project data

Simulator
OPAL-RT · HYPERSIM
Integration
Ignition over DNP3
Status
COMPLETED